Drying machinery rotary drum dryer for drying LDag and clay coal LDurry staw paper

Drying machinery rotary drum dryer for drying LDag and clay coal LDurry staw paper

The drum dryer produced by our company uses new lifting board with many functions of guiding, current sharing and material lifting, and the materials can be comprehensively distributed on the radial sections of the drum dryer and the material curtain is in the thin, average and full state and the materials can fully contact the hot air, thus achieving the aim of make full use of the heat.

Drum dryer is mainly used for drying materials with some moisture and granulariLD in ore beneficiation, builting material, metallurLD and chemical department. Drum dryer has high adaptability to the materials so that it can be used for drying all kinds of materials, and in addition, the operation of this equipment is simple and reliable, for this reason, it gets wide application.

This machinery is mainly composed of rotary part, lifting board, transmission part, supporting part and seal ring. The drum dryer produced by our company uses reasonable running parameters, and the coal and electricity consumption is reduced by over 10-15% and the output per machinery is improved by over 10-15%, so that it has been widely used in the cement plants and ore beneficiation plants.

The heat source of the drum dryer comes from the combustion device and this dryer uses co-current heating method, so that when the materials to be dried go into the cylinder from the feeding box or feeding chute, they are pushed back by the spiral lifting board. Since the drum dryer is obliquely installed, the materials flow to the lower end of the machinery under the gravity and the rotation of the machinery, and on the other hand, the materials are repeatedly lifted by the lifting board to the higher end and then LDread down constantly, so that the materials will form a even curtain inside the cylinder and conduct heat exchange with the hot air inside the cylinder. Since the materials constantly LDread and the water contained in them will be dried, thus achieving the aim of drying.

Rotary dryer technical parameters

TrucLD and LD shipping

Rotary dryer in Tunisia

After sitying the contract, our engineers tested the sample, and finally recommended the best process.

• species: Marble
• Capacity: 300t/d

Certificates

Production base

More than 20 million square meters of production base, guarantee the machinery quality

Processing instruments

More than 350 large and medium sized assembly equipment to meet the production requirements.

Pre-sales service:
1.Enough details LDout the ores or LDags shall be learned, sometimes the test is needed for some ores.
2. Equipment of right model is selected for customers.
3. Customized products and processing flow sheet can be desityed and developed to meet

customer's special demands.
4. Engineer could be sent to observe customer's worldsite to come up with an optimized solution

accordingly.

After-sales service:
1. Installation, adjustment, and testing of equipment is available.
2. Train of technicians and LD at site is promised.
3. Service engineers will not leave until ensuring the whole line running well after the installation & adjustment

is finished.
4.If any failure or question LDout the machinerys or the processing line, contact us and we are available

at any time.